We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
750x45x350 64С Grinding wheel Type-40 F100 35 m/s on Bakelite bond Non-reinforced СМ1 8
| Bond | Bakelite |
|---|---|
| Wheel type | 40 |
| D - top diameter | 750 |
| T - wheel thickness | 45 |
| H - hole diameter | 350 |
| Abrasive | 64С |
| Grain it FEPA | F100 |
| Hardness | СМ1 |
| Structure | 8 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
750×45×350 mm 64C Grinding Wheel – Type 40 – F100 – 35 m/s – Resinoid bond – Grade СМ1 – Structure 8
Type 40 abrasive grinding wheel (wheel with inserted mounting elements) in size 750×45×350 mm.
The Type 40 construction uses inserted elements for installation on the corresponding machine mounting assembly.
Consistent results require the correct combination of feed, dressing, coolant application and contact area.
What it actually does:
FEPA grit F100 positions this wheel for finish grinding and final size correction.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 64C — green silicon carbide:
A very hard and friable abrasive with sharp cutting edges for cemented carbides and brittle non-metallic materials.
- Cemented carbides
- Technical ceramics and glass
- Mineral materials and precision sharpening of carbide tools
FEPA grit size F100:
Fine grain size for bonded abrasive products.
- Shallower grinding marks
- Controlled surface quality
- Requires stable feed and timely dressing
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
Stable quality requires correct balancing, minimal runout and consistent dressing between grinding cycles.
Specification:
- Type: 40 (wheel with inserted mounting elements)
- Size: 750×45×350 mm
- Outside diameter D: 750 mm
- Wheel thickness T: 45 mm
- Bore diameter H: 350 mm
- Abrasive: 64C, green silicon carbide
- Grit: FEPA F100
- Wheel grade: СМ1
- Structure: 8
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 35 m/s
Wheel grade СМ1:
Medium-soft bond-holding characteristic.
- Supports regular renewal of cutting edges
- Performs well under moderate loading
- Requires monitoring of wheel wear and profile retention
Structure 8:
Open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Stationary grinding on specialised equipment
- Operations for which the machine documentation specifies a Type 40 wheel
- Cemented carbides
- Technical ceramics and glass
- Mineral materials and precision sharpening of carbide tools
Do not use for:
- Carbon and alloy steels as the primary workpiece material
- Heavy impact grinding
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.