We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
150x20x32 14A Grinding wheel Type-36 F46 30 m/s on Bakelite bond Non-reinforced J 7
| Bond | Bakelite |
|---|---|
| Wheel type | 36 |
| D - top diameter | 150 |
| T - wheel thickness | 20 |
| H - hole diameter | 32 |
| Abrasive | 14А |
| Grain it FEPA | F46 |
| Hardness | J |
| Structure | 7 |
| Angle speed | 30 |
| Manufacturer | ZAK |
| Country | Ukraine |
150×20×32 mm 14A Grinding Wheel – Type 36 – F46 – 30 m/s – Resinoid bond – Grade J – Structure 7
Type 36 abrasive grinding wheel (straight wheel with inserted mounting elements) in size 150×20×32 mm.
The integrated mounting elements are designed for attachment to a dedicated faceplate on compatible stationary equipment.
Select this wheel with reference to the workpiece material, contact area and required grinding stage.
What it actually does:
FEPA grit F46 positions this wheel for general roughing and semi-finishing.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F46:
Medium grain size for bonded abrasive products.
- Productive material removal
- Suitable for establishing geometry
- Leaves the surface ready for further finishing when tighter requirements apply
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
Stable quality requires correct balancing, minimal runout and consistent dressing between grinding cycles.
Specification:
- Type: 36 (straight wheel with inserted mounting elements)
- Size: 150×20×32 mm
- Outside diameter D: 150 mm
- Wheel thickness T: 20 mm
- Bore diameter H: 32 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F46
- Wheel grade: J
- Structure: 7
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 30 m/s
Wheel grade J:
Medium-soft bond-holding characteristic.
- Supports regular renewal of cutting edges
- Performs well under moderate loading
- Requires monitoring of wheel wear and profile retention
Structure 7:
Moderately open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Stationary surface or face grinding
- Operations using a dedicated wheel mounting system
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 30 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.