We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
750x70x25 25А Grinding wheel Type-40 F46 35 m/s on Bakelite bond Non-reinforced СМ1 8
| Bond | Bakelite |
|---|---|
| Wheel type | 40 |
| D - top diameter | 750 |
| T - wheel thickness | 70 |
| H - hole diameter | 25 |
| Abrasive | 25А |
| Grain it FEPA | F46 |
| Hardness | СМ1 |
| Structure | 8 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
750×70×25 mm 25A Grinding Wheel – Type 40 – F46 – 35 m/s – Resinoid bond – Grade СМ1 – Structure 8
Type 40 abrasive grinding wheel (wheel with inserted mounting elements) in size 750×70×25 mm.
The Type 40 construction uses inserted elements for installation on the corresponding machine mounting assembly.
This specification controls cutting-edge renewal, chip clearance and form retention during grinding.
What it actually does:
FEPA grit F46 positions this wheel for general roughing and semi-finishing.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 25A — white fused aluminium oxide:
A high-purity, sharp and friable grain that renews its cutting edges and helps reduce the risk of thermal damage.
- Hardened and tool steels
- High-speed and alloy steels
- Precision grinding and tool sharpening
FEPA grit size F46:
Medium grain size for bonded abrasive products.
- Productive material removal
- Suitable for establishing geometry
- Leaves the surface ready for further finishing when tighter requirements apply
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
Stable quality requires correct balancing, minimal runout and consistent dressing between grinding cycles.
Specification:
- Type: 40 (wheel with inserted mounting elements)
- Size: 750×70×25 mm
- Outside diameter D: 750 mm
- Wheel thickness T: 70 mm
- Bore diameter H: 25 mm
- Abrasive: 25A, white fused aluminium oxide
- Grit: FEPA F46
- Wheel grade: СМ1
- Structure: 8
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 35 m/s
Wheel grade СМ1:
Medium-soft bond-holding characteristic.
- Supports regular renewal of cutting edges
- Performs well under moderate loading
- Requires monitoring of wheel wear and profile retention
Structure 8:
Open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Stationary grinding on specialised equipment
- Operations for which the machine documentation specifies a Type 40 wheel
- Hardened and tool steels
- High-speed and alloy steels
- Precision grinding and tool sharpening
Do not use for:
- Cemented carbide, glass and ceramics, where silicon carbide is generally more suitable
- Heavy snagging with severe impact loading
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.