We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
750x200x350 14А Grinding wheel Type-5 F60 35 m/s on Bakelite bond Non-reinforced СМ1 7
| Bond | Bakelite |
|---|---|
| Wheel type | 5 |
| D - top diameter | 750 |
| T - wheel thickness | 200 |
| H - hole diameter | 350 |
| Abrasive | 14А |
| Grain it FEPA | F60 |
| Hardness | СМ1 |
| Structure | 7 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
750×200×350 mm 14A Grinding Wheel – Type 5 – F60 – 35 m/s – Resinoid bond – Grade СМ1 – Structure 7
Type 5 abrasive grinding wheel (single-recessed straight wheel) in size 750×200×350 mm.
The recess provides flange clearance and positions the working periphery relative to the machine spindle assembly.
Its working behaviour is defined by the combination of wheel profile, abrasive grain, grade and porosity.
What it actually does:
FEPA grit F60 positions this wheel for semi-finish grinding with controlled stock removal.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F60:
Medium-fine grain size for bonded abrasive products.
- Balanced cutting performance
- A more uniform surface than coarse grits
- Suitable preparation for a finishing pass
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
Use a grinding load that keeps the grains cutting rather than rubbing continuously against the workpiece.
Specification:
- Type: 5 (single-recessed straight wheel)
- Size: 750×200×350 mm
- Outside diameter D: 750 mm
- Wheel thickness T: 200 mm
- Bore diameter H: 350 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F60
- Wheel grade: СМ1
- Structure: 7
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 35 m/s
Wheel grade СМ1:
Medium-soft bond-holding characteristic.
- Supports regular renewal of cutting edges
- Performs well under moderate loading
- Requires monitoring of wheel wear and profile retention
Structure 7:
Moderately open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Peripheral grinding
- Operations requiring a single-recess mounting arrangement
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.