We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
400x10x203 14А Grinding wheel Type-4 F120 35 m/s on Ceramic bond M 7
| Bond | Ceramic |
|---|---|
| Wheel type | 4 |
| D - top diameter | 400 |
| T - wheel thickness | 10 |
| H - hole diameter | 203 |
| Abrasive | 14А |
| Grain it FEPA | F120 |
| Hardness | M |
| Structure | 7 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
400×10×203 mm 14A Grinding Wheel – Type 4 – F120 – 35 m/s – Vitrified bond – Grade M – Structure 7
Type 4 abrasive grinding wheel (double-taper wheel) in size 400×10×203 mm.
Tapering on both sides improves access to narrow areas and supports profile generation from either side of the wheel.
These parameters balance stock removal, wheel life and surface quality for the intended operation.
What it actually does:
FEPA grit F120 positions this wheel for fine finishing and precision sizing.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F120:
Very fine grain size for bonded abrasive products.
- Low stock removal per pass
- High surface uniformity
- Sensitive to overloading and wheel loading
Vitrified bond:
- Provides strong form retention
- Can be dressed accurately
- Its porous matrix helps remove chips and heat
Limitation: Vitrified wheels are sensitive to impact and unauthorised side loading.
In practice:
Stable quality requires correct balancing, minimal runout and consistent dressing between grinding cycles.
Specification:
- Type: 4 (double-taper wheel)
- Size: 400×10×203 mm
- Outside diameter D: 400 mm
- Wheel thickness T: 10 mm
- Bore diameter H: 203 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F120
- Wheel grade: M
- Structure: 7
- Bond: vitrified
- Maximum operating speed: 35 m/s
Wheel grade M:
Medium bond-holding characteristic.
- Balances self-sharpening and wheel life
- Stable performance with a consistent feed
- A versatile grade for steady grinding contact
Structure 7:
Moderately open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Profile grinding
- Grinding grooves and complex contours on compatible equipment
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.