We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
600x75x305 14А Grinding wheel Type-36 F46 35 m/s on Bakelite bond Non-reinforced С2 8
| Bond | Bakelite |
|---|---|
| Wheel type | 36 |
| D - top diameter | 600 |
| T - wheel thickness | 75 |
| H - hole diameter | 305 |
| Abrasive | 14А |
| Grain it FEPA | F46 |
| Hardness | С2 |
| Structure | 8 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
600×75×305 mm 14A Grinding Wheel – Type 36 – F46 – 35 m/s – Resinoid bond – Grade С2 – Structure 8
Type 36 abrasive grinding wheel (straight wheel with inserted mounting elements) in size 600×75×305 mm.
The integrated mounting elements are designed for attachment to a dedicated faceplate on compatible stationary equipment.
Performance depends not only on the dimensions, but also on the abrasive type, grit size, grade and structure.
What it actually does:
FEPA grit F46 positions this wheel for general roughing and semi-finishing.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F46:
Medium grain size for bonded abrasive products.
- Productive material removal
- Suitable for establishing geometry
- Leaves the surface ready for further finishing when tighter requirements apply
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
Stable quality requires correct balancing, minimal runout and consistent dressing between grinding cycles.
Specification:
- Type: 36 (straight wheel with inserted mounting elements)
- Size: 600×75×305 mm
- Outside diameter D: 600 mm
- Wheel thickness T: 75 mm
- Bore diameter H: 305 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F46
- Wheel grade: С2
- Structure: 8
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 35 m/s
Wheel grade С2:
Medium bond-holding characteristic.
- Balances self-sharpening and wheel life
- Stable performance with a consistent feed
- A versatile grade for steady grinding contact
Structure 8:
Open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Stationary surface or face grinding
- Operations using a dedicated wheel mounting system
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.