We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
762x70x406 14А Grinding wheel Type-36 F100 35 m/s on Bakelite bond Non-reinforced М3 8
| Bond | Bakelite |
|---|---|
| Wheel type | 36 |
| D - top diameter | 762 |
| T - wheel thickness | 70 |
| H - hole diameter | 406 |
| Abrasive | 14А |
| Grain it FEPA | F100 |
| Hardness | М3 |
| Structure | 8 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
762×70×406 mm 14A Grinding Wheel – Type 36 – F100 – 35 m/s – Resinoid bond – Grade М3 – Structure 8
Type 36 abrasive grinding wheel (straight wheel with inserted mounting elements) in size 762×70×406 mm.
The integrated mounting elements are designed for attachment to a dedicated faceplate on compatible stationary equipment.
The specification is intended to provide predictable cutting action and stable development of the working surface.
What it actually does:
FEPA grit F100 positions this wheel for finish grinding and final size correction.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F100:
Fine grain size for bonded abrasive products.
- Shallower grinding marks
- Controlled surface quality
- Requires stable feed and timely dressing
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
Stable quality requires correct balancing, minimal runout and consistent dressing between grinding cycles.
Specification:
- Type: 36 (straight wheel with inserted mounting elements)
- Size: 762×70×406 mm
- Outside diameter D: 762 mm
- Wheel thickness T: 70 mm
- Bore diameter H: 406 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F100
- Wheel grade: М3
- Structure: 8
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 35 m/s
Wheel grade М3:
Soft bond-holding characteristic.
- Releases worn abrasive grains relatively quickly
- Promotes cooler cutting on hard workpiece materials
- Wears faster than harder wheel grades
Structure 8:
Open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Stationary surface or face grinding
- Operations using a dedicated wheel mounting system
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.