We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
150x80x32 54С Grinding wheel Type-6 F46 30 m/s on Ceramic bond L 8
| Bond | Ceramic |
|---|---|
| Wheel type | 6 |
| D - top diameter | 150 |
| T - wheel thickness | 80 |
| H - hole diameter | 32 |
| Abrasive | 54С |
| Grain it FEPA | F46 |
| Hardness | L |
| Structure | 8 |
| Angle speed | 30 |
| Manufacturer | ZAK |
| Country | Ukraine |
150×80×32 mm 54C Grinding Wheel – Type 6 – F46 – 30 m/s – Vitrified bond – Grade L – Structure 8
Type 6 abrasive grinding wheel (straight cup wheel) in size 150×80×32 mm.
The cup geometry works primarily on its face and is used for surface grinding and tool sharpening on compatible machines.
Performance depends not only on the dimensions, but also on the abrasive type, grit size, grade and structure.
What it actually does:
FEPA grit F46 positions this wheel for general roughing and semi-finishing.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 54C — black silicon carbide:
A hard, sharp abrasive for low-tensile-strength materials and hard non-metallic surfaces.
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
FEPA grit size F46:
Medium grain size for bonded abrasive products.
- Productive material removal
- Suitable for establishing geometry
- Leaves the surface ready for further finishing when tighter requirements apply
Vitrified bond:
- Provides strong form retention
- Can be dressed accurately
- Its porous matrix helps remove chips and heat
Limitation: Vitrified wheels are sensitive to impact and unauthorised side loading.
In practice:
Use a grinding load that keeps the grains cutting rather than rubbing continuously against the workpiece.
Specification:
- Type: 6 (straight cup wheel)
- Size: 150×80×32 mm
- Outside diameter D: 150 mm
- Wheel thickness T: 80 mm
- Bore diameter H: 32 mm
- Abrasive: 54C, black silicon carbide
- Grit: FEPA F46
- Wheel grade: L
- Structure: 8
- Bond: vitrified
- Maximum operating speed: 30 m/s
Wheel grade L:
Medium-soft bond-holding characteristic.
- Supports regular renewal of cutting edges
- Performs well under moderate loading
- Requires monitoring of wheel wear and profile retention
Structure 8:
Open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Face grinding of flat surfaces
- Tool sharpening with the cup face
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
Do not use for:
- General-purpose grinding of carbon and alloy steels
- Operations with severe impact on the brittle abrasive grain
- Side loading unless specifically permitted by the wheel design
- Operation above 30 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.