We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
100x50x20 25А Grinding wheel Type-6 F46 30 m/s on Ceramic bond K 7
| Bond | Ceramic |
|---|---|
| Wheel type | 6 |
| D - top diameter | 100 |
| T - wheel thickness | 50 |
| H - hole diameter | 20 |
| Abrasive | 25А |
| Grain it FEPA | F46 |
| Hardness | K |
| Structure | 7 |
| Angle speed | 30 |
| Manufacturer | ZAK |
| Country | Ukraine |
100×50×20 mm 25A Grinding Wheel – Type 6 – F46 – 30 m/s – Vitrified bond – Grade K – Structure 7
Type 6 abrasive grinding wheel (straight cup wheel) in size 100×50×20 mm.
The cup geometry works primarily on its face and is used for surface grinding and tool sharpening on compatible machines.
This specification controls cutting-edge renewal, chip clearance and form retention during grinding.
What it actually does:
FEPA grit F46 positions this wheel for general roughing and semi-finishing.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 25A — white fused aluminium oxide:
A high-purity, sharp and friable grain that renews its cutting edges and helps reduce the risk of thermal damage.
- Hardened and tool steels
- High-speed and alloy steels
- Precision grinding and tool sharpening
FEPA grit size F46:
Medium grain size for bonded abrasive products.
- Productive material removal
- Suitable for establishing geometry
- Leaves the surface ready for further finishing when tighter requirements apply
Vitrified bond:
- Provides strong form retention
- Can be dressed accurately
- Its porous matrix helps remove chips and heat
Limitation: Vitrified wheels are sensitive to impact and unauthorised side loading.
In practice:
Use a grinding load that keeps the grains cutting rather than rubbing continuously against the workpiece.
Specification:
- Type: 6 (straight cup wheel)
- Size: 100×50×20 mm
- Outside diameter D: 100 mm
- Wheel thickness T: 50 mm
- Bore diameter H: 20 mm
- Abrasive: 25A, white fused aluminium oxide
- Grit: FEPA F46
- Wheel grade: K
- Structure: 7
- Bond: vitrified
- Maximum operating speed: 30 m/s
Wheel grade K:
Medium-soft bond-holding characteristic.
- Supports regular renewal of cutting edges
- Performs well under moderate loading
- Requires monitoring of wheel wear and profile retention
Structure 7:
Moderately open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Face grinding of flat surfaces
- Tool sharpening with the cup face
- Hardened and tool steels
- High-speed and alloy steels
- Precision grinding and tool sharpening
Do not use for:
- Cemented carbide, glass and ceramics, where silicon carbide is generally more suitable
- Heavy snagging with severe impact loading
- Side loading unless specifically permitted by the wheel design
- Operation above 30 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.