We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
250x63x127 54С Grinding wheel Type-7 F20 25 m/s on Ceramic bond O 3
| Bond | Ceramic |
|---|---|
| Wheel type | 7 |
| D - top diameter | 250 |
| T - wheel thickness | 63 |
| H - hole diameter | 127 |
| Abrasive | 54С |
| Grain it FEPA | F20 |
| Hardness | O |
| Structure | 3 |
| Angle speed | 25 |
| Manufacturer | ZAK |
| Country | Ukraine |
250×63×127 mm 54C Grinding Wheel – Type 7 – F20 – 25 m/s – Vitrified bond – Grade O – Structure 3
Type 7 abrasive grinding wheel (double-recessed straight wheel) in size 250×63×127 mm.
Recesses on both sides provide flange clearance while leaving the outer periphery available for grinding.
This wheel size is intended for stationary grinding under parameters matched to the machine and workpiece material.
What it actually does:
FEPA grit F20 positions this wheel for heavy rough grinding with a high stock-removal rate.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 54C — black silicon carbide:
A hard, sharp abrasive for low-tensile-strength materials and hard non-metallic surfaces.
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
FEPA grit size F20:
Very coarse to coarse grain size for bonded abrasive products.
- High stock-removal capacity
- A pronounced abrasive scratch pattern
- Usually requires an allowance for subsequent finishing
Vitrified bond:
- Provides strong form retention
- Can be dressed accurately
- Its porous matrix helps remove chips and heat
Limitation: Vitrified wheels are sensitive to impact and unauthorised side loading.
In practice:
With a large contact area, chip clearance, coolant supply and timely opening of the wheel face become especially important.
Specification:
- Type: 7 (double-recessed straight wheel)
- Size: 250×63×127 mm
- Outside diameter D: 250 mm
- Wheel thickness T: 63 mm
- Bore diameter H: 127 mm
- Abrasive: 54C, black silicon carbide
- Grit: FEPA F20
- Wheel grade: O
- Structure: 3
- Bond: vitrified
- Maximum operating speed: 25 m/s
Wheel grade O:
Medium-hard bond-holding characteristic.
- Retains abrasive grains more strongly
- Maintains the working profile well
- May glaze if the grinding load is too low
Structure 3:
Dense wheel structure.
- High abrasive-grain concentration
- Good retention of the working form
- Requires careful control of loading and heat generation
Use for:
- Peripheral grinding
- Stationary grinding with double-flange mounting
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
Do not use for:
- General-purpose grinding of carbon and alloy steels
- Operations with severe impact on the brittle abrasive grain
- Side loading unless specifically permitted by the wheel design
- Operation above 25 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.