We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
200x63x50 14А Grinding wheel Type-6 F60 30 m/s on Bakelite bond Non-reinforced СМ1 6
| Bond | Bakelite |
|---|---|
| Wheel type | 6 |
| D - top diameter | 200 |
| T - wheel thickness | 63 |
| H - hole diameter | 50 |
| Abrasive | 14А |
| Grain it FEPA | F60 |
| Hardness | СМ1 |
| Structure | 6 |
| Angle speed | 30 |
| Manufacturer | ZAK |
| Country | Ukraine |
200×63×50 mm 14A Grinding Wheel – Type 6 – F60 – 30 m/s – Resinoid bond – Grade СМ1 – Structure 6
Type 6 abrasive grinding wheel (straight cup wheel) in size 200×63×50 mm.
The cup geometry works primarily on its face and is used for surface grinding and tool sharpening on compatible machines.
The abrasive, grit size and structure determine the stock-removal behaviour and the resulting surface condition.
What it actually does:
FEPA grit F60 positions this wheel for semi-finish grinding with controlled stock removal.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F60:
Medium-fine grain size for bonded abrasive products.
- Balanced cutting performance
- A more uniform surface than coarse grits
- Suitable preparation for a finishing pass
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
With a large contact area, chip clearance, coolant supply and timely opening of the wheel face become especially important.
Specification:
- Type: 6 (straight cup wheel)
- Size: 200×63×50 mm
- Outside diameter D: 200 mm
- Wheel thickness T: 63 mm
- Bore diameter H: 50 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F60
- Wheel grade: СМ1
- Structure: 6
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 30 m/s
Wheel grade СМ1:
Medium-soft bond-holding characteristic.
- Supports regular renewal of cutting edges
- Performs well under moderate loading
- Requires monitoring of wheel wear and profile retention
Structure 6:
Medium wheel structure.
- Balanced grain and pore volume
- Stable form retention
- Predictable performance under consistent loading
Use for:
- Face grinding of flat surfaces
- Tool sharpening with the cup face
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 30 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.