We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
300x10x60 14А Grinding wheel Type-1 F54 50 m/s on Bakelite bond Non-reinforced O(СТ1) 5
| Bond | Bakelite |
|---|---|
| Wheel type | 1 |
| D - top diameter | 300 |
| T - wheel thickness | 10 |
| H - hole diameter | 60 |
| Abrasive | 14А |
| Grain it FEPA | F54 |
| Hardness | O(СТ1) |
| Structure | 5 |
| Angle speed | 50 |
| Manufacturer | ZAK |
| Country | Ukraine |
300×10×60 mm 14A Grinding Wheel – Type 1 – F54 – 50 m/s – Resinoid bond – Grade O(СТ1) – Structure 5
Type 1 abrasive grinding wheel (straight wheel) in size 300×10×60 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
These parameters balance stock removal, wheel life and surface quality for the intended operation.
What it actually does:
FEPA grit F54 positions this wheel for semi-finish grinding with controlled stock removal.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F54:
Medium-fine grain size for bonded abrasive products.
- Balanced cutting performance
- A more uniform surface than coarse grits
- Suitable preparation for a finishing pass
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
Repeatable results depend on accurate dressing, system rigidity and a consistent feed rate.
Specification:
- Type: 1 (straight wheel)
- Size: 300×10×60 mm
- Outside diameter D: 300 mm
- Wheel thickness T: 10 mm
- Bore diameter H: 60 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F54
- Wheel grade: O(СТ1)
- Structure: 5
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 50 m/s
Wheel grade O(СТ1):
Medium-hard bond-holding characteristic.
- Retains abrasive grains more strongly
- Maintains the working profile well
- May glaze if the grinding load is too low
Structure 5:
Medium wheel structure.
- Balanced grain and pore volume
- Stable form retention
- Predictable performance under consistent loading
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 50 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.