250x20x32 14А Grinding wheel Type-1 F22 40 m/s on Bakelite bond Non-reinforced СТ1 2

In stock
SKU
321234-1
$16.07
More Information
Bond Bakelite
Wheel type 1
D - top diameter 250
T - wheel thickness 20
H - hole diameter 32
Abrasive 14А
Grain it FEPA F22
Hardness СТ1
Structure 2
Angle speed 40
Manufacturer ZAK
Country Ukraine

250×20×32 mm 14A Grinding Wheel – Type 1 – F22 – 40 m/s – Resinoid bond – Grade СТ1 – Structure 2

Type 1 abrasive grinding wheel (straight wheel) in size 250×20×32 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.

This wheel size is intended for stationary grinding under parameters matched to the machine and workpiece material.

What it actually does:

FEPA grit F22 positions this wheel for heavy rough grinding with a high stock-removal rate.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.

Abrasive 14A — regular aluminium oxide:

A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.

  • Carbon and low-alloy steels
  • Steel billets, forgings and castings
  • Rough and semi-finish grinding

FEPA grit size F22:

Very coarse to coarse grain size for bonded abrasive products.

  • High stock-removal capacity
  • A pronounced abrasive scratch pattern
  • Usually requires an allowance for subsequent finishing

Resinoid bond:

  • More resilient than a vitrified bond
  • Tolerates dynamic grinding loads
  • Suitable for productive stock removal

Limitation: The non-reinforced construction must be used only on compatible stationary equipment.

In practice:

Repeatable results depend on accurate dressing, system rigidity and a consistent feed rate.

Specification:

  • Type: 1 (straight wheel)
  • Size: 250×20×32 mm
  • Outside diameter D: 250 mm
  • Wheel thickness T: 20 mm
  • Bore diameter H: 32 mm
  • Abrasive: 14A, regular aluminium oxide
  • Grit: FEPA F22
  • Wheel grade: СТ1
  • Structure: 2
  • Bond: resinoid (Bakelite), non-reinforced
  • Maximum operating speed: 40 m/s

Wheel grade СТ1:

Medium-hard bond-holding characteristic.

  • Retains abrasive grains more strongly
  • Maintains the working profile well
  • May glaze if the grinding load is too low

Structure 2:

Dense wheel structure.

  • High abrasive-grain concentration
  • Good retention of the working form
  • Requires careful control of loading and heat generation

Use for:

  • Peripheral grinding
  • Sharpening and sizing of working surfaces
  • Carbon and low-alloy steels
  • Steel billets, forgings and castings
  • Rough and semi-finish grinding

Do not use for:

  • Cemented carbide and technical ceramics
  • Precision grinding of hardened steel where a cooler-cutting friable grain is required
  • Side loading unless specifically permitted by the wheel design
  • Operation above 40 m/s

Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.

Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account
© Copyright - e-Store "Razvertka" Tokar tools - production and sale of tools You may not copy, reproduce, modify, publish, upload, transmit, and distribute any elements of this site, as well as their components, by any means and in any media without prior written permission.