We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
110x55x22.23 54С Grinding wheel Type-11 F24 50 m/s on Bakelite bond Non-reinforced P 2
| Bond | Bakelite |
|---|---|
| Wheel type | 11 |
| D - top diameter | 110 |
| T - wheel thickness | 55 |
| H - hole diameter | 22.23 |
| Abrasive | 54С |
| Grain it FEPA | F24 |
| Hardness | P |
| Structure | 2 |
| Angle speed | 50 |
| Manufacturer | ZAK |
| Country | Ukraine |
110×55×22.23 mm 54C Grinding Wheel – Type 11 – F24 – 50 m/s – Resinoid bond – Grade P – Structure 2
Type 11 abrasive grinding wheel (flaring cup wheel) in size 110×55×22.23 mm.
The flaring cup shape allows face or peripheral contact and provides convenient access to cutting edges during tool sharpening.
Select this wheel with reference to the workpiece material, contact area and required grinding stage.
What it actually does:
FEPA grit F24 positions this wheel for heavy rough grinding with a high stock-removal rate.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 54C — black silicon carbide:
A hard, sharp abrasive for low-tensile-strength materials and hard non-metallic surfaces.
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
FEPA grit size F24:
Very coarse to coarse grain size for bonded abrasive products.
- High stock-removal capacity
- A pronounced abrasive scratch pattern
- Usually requires an allowance for subsequent finishing
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
If cutting action gives way to excessive rubbing, check the dressing condition, feed and coolant delivery.
Specification:
- Type: 11 (flaring cup wheel)
- Size: 110×55×22.23 mm
- Outside diameter D: 110 mm
- Wheel thickness T: 55 mm
- Bore diameter H: 22.23 mm
- Abrasive: 54C, black silicon carbide
- Grit: FEPA F24
- Wheel grade: P
- Structure: 2
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 50 m/s
Wheel grade P:
Medium-hard bond-holding characteristic.
- Retains abrasive grains more strongly
- Maintains the working profile well
- May glaze if the grinding load is too low
Structure 2:
Dense wheel structure.
- High abrasive-grain concentration
- Good retention of the working form
- Requires careful control of loading and heat generation
Use for:
- Tool sharpening
- Face and profile grinding on compatible equipment
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
Do not use for:
- General-purpose grinding of carbon and alloy steels
- Operations with severe impact on the brittle abrasive grain
- Side loading unless specifically permitted by the wheel design
- Operation above 50 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.