We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
150x50x32 14А Grinding wheel Type-11 F46 30 m/s on Ceramic bond СМ2 7
| Bond | Ceramic |
|---|---|
| Wheel type | 11 |
| D - top diameter | 150 |
| T - wheel thickness | 50 |
| H - hole diameter | 32 |
| Abrasive | 14А |
| Grain it FEPA | F46 |
| Hardness | СМ2 |
| Structure | 7 |
| Angle speed | 30 |
| Manufacturer | ZAK |
| Country | Ukraine |
150×50×32 mm 14A Grinding Wheel – Type 11 – F46 – 30 m/s – Vitrified bond – Grade СМ2 – Structure 7
Type 11 abrasive grinding wheel (flaring cup wheel) in size 150×50×32 mm.
The flaring cup shape allows face or peripheral contact and provides convenient access to cutting edges during tool sharpening.
The wheel acts as a multi-point cutting tool and must be installed on equipment designed for its mounting profile.
What it actually does:
FEPA grit F46 positions this wheel for general roughing and semi-finishing.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F46:
Medium grain size for bonded abrasive products.
- Productive material removal
- Suitable for establishing geometry
- Leaves the surface ready for further finishing when tighter requirements apply
Vitrified bond:
- Provides strong form retention
- Can be dressed accurately
- Its porous matrix helps remove chips and heat
Limitation: Vitrified wheels are sensitive to impact and unauthorised side loading.
In practice:
Repeatable results depend on accurate dressing, system rigidity and a consistent feed rate.
Specification:
- Type: 11 (flaring cup wheel)
- Size: 150×50×32 mm
- Outside diameter D: 150 mm
- Wheel thickness T: 50 mm
- Bore diameter H: 32 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F46
- Wheel grade: СМ2
- Structure: 7
- Bond: vitrified
- Maximum operating speed: 30 m/s
Wheel grade СМ2:
Medium-soft bond-holding characteristic.
- Supports regular renewal of cutting edges
- Performs well under moderate loading
- Requires monitoring of wheel wear and profile retention
Structure 7:
Moderately open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Tool sharpening
- Face and profile grinding on compatible equipment
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 30 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.