We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
350x40x127 14А Grinding wheel Type-1 F22 50 m/s on Bakelite bond Non-reinforced O 3
| Bond | Bakelite |
|---|---|
| Wheel type | 1 |
| D - top diameter | 350 |
| T - wheel thickness | 40 |
| H - hole diameter | 127 |
| Abrasive | 14А |
| Grain it FEPA | F22 |
| Hardness | O |
| Structure | 3 |
| Angle speed | 50 |
| Manufacturer | ZAK |
| Country | Ukraine |
350×40×127 mm 14A Grinding Wheel – Type 1 – F22 – 50 m/s – Resinoid bond – Grade O – Structure 3
Type 1 abrasive grinding wheel (straight wheel) in size 350×40×127 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
This specification is designed for controlled grinding based on the abrasive type, grit size, wheel grade and structure.
What it actually does:
FEPA grit F22 positions this wheel for heavy rough grinding with a high stock-removal rate.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F22:
Very coarse to coarse grain size for bonded abrasive products.
- High stock-removal capacity
- A pronounced abrasive scratch pattern
- Usually requires an allowance for subsequent finishing
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
Repeatable results depend on accurate dressing, system rigidity and a consistent feed rate.
Specification:
- Type: 1 (straight wheel)
- Size: 350×40×127 mm
- Outside diameter D: 350 mm
- Wheel thickness T: 40 mm
- Bore diameter H: 127 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F22
- Wheel grade: O
- Structure: 3
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 50 m/s
Wheel grade O:
Medium-hard bond-holding characteristic.
- Retains abrasive grains more strongly
- Maintains the working profile well
- May glaze if the grinding load is too low
Structure 3:
Dense wheel structure.
- High abrasive-grain concentration
- Good retention of the working form
- Requires careful control of loading and heat generation
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 50 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.