We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
125x50x32 14А Grinding wheel Type-11 F22 30 m/s on Bakelite bond Non-reinforced СТ1 3
| Bond | Bakelite |
|---|---|
| Wheel type | 11 |
| D - top diameter | 125 |
| T - wheel thickness | 50 |
| H - hole diameter | 32 |
| Abrasive | 14А |
| Grain it FEPA | F22 |
| Hardness | СТ1 |
| Structure | 3 |
| Angle speed | 30 |
| Manufacturer | ZAK |
| Country | Ukraine |
125×50×32 mm 14A Grinding Wheel – Type 11 – F22 – 30 m/s – Resinoid bond – Grade СТ1 – Structure 3
Type 11 abrasive grinding wheel (flaring cup wheel) in size 125×50×32 mm.
The flaring cup shape allows face or peripheral contact and provides convenient access to cutting edges during tool sharpening.
The wheel acts as a multi-point cutting tool and must be installed on equipment designed for its mounting profile.
What it actually does:
FEPA grit F22 positions this wheel for heavy rough grinding with a high stock-removal rate.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F22:
Very coarse to coarse grain size for bonded abrasive products.
- High stock-removal capacity
- A pronounced abrasive scratch pattern
- Usually requires an allowance for subsequent finishing
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
If cutting action gives way to excessive rubbing, check the dressing condition, feed and coolant delivery.
Specification:
- Type: 11 (flaring cup wheel)
- Size: 125×50×32 mm
- Outside diameter D: 125 mm
- Wheel thickness T: 50 mm
- Bore diameter H: 32 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F22
- Wheel grade: СТ1
- Structure: 3
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 30 m/s
Wheel grade СТ1:
Medium-hard bond-holding characteristic.
- Retains abrasive grains more strongly
- Maintains the working profile well
- May glaze if the grinding load is too low
Structure 3:
Dense wheel structure.
- High abrasive-grain concentration
- Good retention of the working form
- Requires careful control of loading and heat generation
Use for:
- Tool sharpening
- Face and profile grinding on compatible equipment
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 30 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.