We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
150x8x32 64С Grinding wheel Type-3 F80 35 m/s on Ceramic bond O 7
| Bond | Ceramic |
|---|---|
| Wheel type | 3 |
| D - top diameter | 150 |
| T - wheel thickness | 8 |
| H - hole diameter | 32 |
| Abrasive | 64С |
| Grain it FEPA | F80 |
| Hardness | O |
| Structure | 7 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
150×8×32 mm 64C Grinding Wheel – Type 3 – F80 – 35 m/s – Vitrified bond – Grade O – Structure 7
Type 3 abrasive grinding wheel (single-taper wheel) in size 150×8×32 mm.
The tapered side improves access to the workpiece profile and supports localised contact in specialised grinding operations.
This specification is designed for controlled grinding based on the abrasive type, grit size, wheel grade and structure.
What it actually does:
FEPA grit F80 positions this wheel for finish grinding and final size correction.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 64C — green silicon carbide:
A very hard and friable abrasive with sharp cutting edges for cemented carbides and brittle non-metallic materials.
- Cemented carbides
- Technical ceramics and glass
- Mineral materials and precision sharpening of carbide tools
FEPA grit size F80:
Fine grain size for bonded abrasive products.
- Shallower grinding marks
- Controlled surface quality
- Requires stable feed and timely dressing
Vitrified bond:
- Provides strong form retention
- Can be dressed accurately
- Its porous matrix helps remove chips and heat
Limitation: Vitrified wheels are sensitive to impact and unauthorised side loading.
In practice:
Stable quality requires correct balancing, minimal runout and consistent dressing between grinding cycles.
Specification:
- Type: 3 (single-taper wheel)
- Size: 150×8×32 mm
- Outside diameter D: 150 mm
- Wheel thickness T: 8 mm
- Bore diameter H: 32 mm
- Abrasive: 64C, green silicon carbide
- Grit: FEPA F80
- Wheel grade: O
- Structure: 7
- Bond: vitrified
- Maximum operating speed: 35 m/s
Wheel grade O:
Medium-hard bond-holding characteristic.
- Retains abrasive grains more strongly
- Maintains the working profile well
- May glaze if the grinding load is too low
Structure 7:
Moderately open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Profile grinding
- Operations requiring access with a tapered wheel side
- Cemented carbides
- Technical ceramics and glass
- Mineral materials and precision sharpening of carbide tools
Do not use for:
- Carbon and alloy steels as the primary workpiece material
- Heavy impact grinding
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.