We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
250x25x76 54С Grinding wheel Type-3 F60 35 m/s on Ceramic bond СМ2 7
| Bond | Ceramic |
|---|---|
| Wheel type | 3 |
| D - top diameter | 250 |
| T - wheel thickness | 25 |
| H - hole diameter | 76 |
| Abrasive | 54С |
| Grain it FEPA | F60 |
| Hardness | СМ2 |
| Structure | 7 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
250×25×76 mm 54C Grinding Wheel – Type 3 – F60 – 35 m/s – Vitrified bond – Grade СМ2 – Structure 7
Type 3 abrasive grinding wheel (single-taper wheel) in size 250×25×76 mm.
The tapered side improves access to the workpiece profile and supports localised contact in specialised grinding operations.
This specification controls cutting-edge renewal, chip clearance and form retention during grinding.
What it actually does:
FEPA grit F60 positions this wheel for semi-finish grinding with controlled stock removal.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 54C — black silicon carbide:
A hard, sharp abrasive for low-tensile-strength materials and hard non-metallic surfaces.
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
FEPA grit size F60:
Medium-fine grain size for bonded abrasive products.
- Balanced cutting performance
- A more uniform surface than coarse grits
- Suitable preparation for a finishing pass
Vitrified bond:
- Provides strong form retention
- Can be dressed accurately
- Its porous matrix helps remove chips and heat
Limitation: Vitrified wheels are sensitive to impact and unauthorised side loading.
In practice:
Set the final operating parameters for the actual workpiece material and hardness without exceeding the marked wheel speed.
Specification:
- Type: 3 (single-taper wheel)
- Size: 250×25×76 mm
- Outside diameter D: 250 mm
- Wheel thickness T: 25 mm
- Bore diameter H: 76 mm
- Abrasive: 54C, black silicon carbide
- Grit: FEPA F60
- Wheel grade: СМ2
- Structure: 7
- Bond: vitrified
- Maximum operating speed: 35 m/s
Wheel grade СМ2:
Medium-soft bond-holding characteristic.
- Supports regular renewal of cutting edges
- Performs well under moderate loading
- Requires monitoring of wheel wear and profile retention
Structure 7:
Moderately open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Profile grinding
- Operations requiring access with a tapered wheel side
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
Do not use for:
- General-purpose grinding of carbon and alloy steels
- Operations with severe impact on the brittle abrasive grain
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.