We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
450x150x100 14А Grinding wheel Type-2 F60 35 m/s on Bakelite bond Non-reinforced М3 6
| Bond | Bakelite |
|---|---|
| Wheel type | 2 |
| D - top diameter | 450 |
| T - wheel thickness | 150 |
| H - hole diameter | 100 |
| Abrasive | 14А |
| Grain it FEPA | F60 |
| Hardness | М3 |
| Structure | 6 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
450×150×100 mm 14A Grinding Wheel – Type 2 – F60 – 35 m/s – Resinoid bond – Grade М3 – Structure 6
Type 2 abrasive grinding wheel (cylinder or ring wheel) in size 450×150×100 mm.
A ring-shaped wheel intended mainly for face grinding over a broad contact area on dedicated equipment.
The wheel acts as a multi-point cutting tool and must be installed on equipment designed for its mounting profile.
What it actually does:
FEPA grit F60 positions this wheel for semi-finish grinding with controlled stock removal.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F60:
Medium-fine grain size for bonded abrasive products.
- Balanced cutting performance
- A more uniform surface than coarse grits
- Suitable preparation for a finishing pass
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
Set the final operating parameters for the actual workpiece material and hardness without exceeding the marked wheel speed.
Specification:
- Type: 2 (cylinder or ring wheel)
- Size: 450×150×100 mm
- Outside diameter D: 450 mm
- Wheel thickness T: 150 mm
- Bore diameter H: 100 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F60
- Wheel grade: М3
- Structure: 6
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 35 m/s
Wheel grade М3:
Soft bond-holding characteristic.
- Releases worn abrasive grains relatively quickly
- Promotes cooler cutting on hard workpiece materials
- Wears faster than harder wheel grades
Structure 6:
Medium wheel structure.
- Balanced grain and pore volume
- Stable form retention
- Predictable performance under consistent loading
Use for:
- Face grinding
- Surface grinding on compatible ring-wheel machines
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.