We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
600x63x305 14А Grinding wheel Type-1 F16 50 m/s on Bakelite bond Non-reinforced СТ1 2
| Bond | Bakelite |
|---|---|
| Wheel type | 1 |
| D - top diameter | 600 |
| T - wheel thickness | 63 |
| H - hole diameter | 305 |
| Abrasive | 14А |
| Grain it FEPA | F16 |
| Hardness | СТ1 |
| Structure | 2 |
| Angle speed | 50 |
| Manufacturer | ZAK |
| Country | Ukraine |
600×63×305 mm 14A Grinding Wheel – Type 1 – F16 – 50 m/s – Resinoid bond – Grade СТ1 – Structure 2
Type 1 abrasive grinding wheel (straight wheel) in size 600×63×305 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
These parameters balance stock removal, wheel life and surface quality for the intended operation.
What it actually does:
FEPA grit F16 positions this wheel for heavy rough grinding with a high stock-removal rate.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F16:
Very coarse to coarse grain size for bonded abrasive products.
- High stock-removal capacity
- A pronounced abrasive scratch pattern
- Usually requires an allowance for subsequent finishing
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
Before production use, make a trial pass and check heat generation, stock removal and the condition of the wheel face.
Specification:
- Type: 1 (straight wheel)
- Size: 600×63×305 mm
- Outside diameter D: 600 mm
- Wheel thickness T: 63 mm
- Bore diameter H: 305 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F16
- Wheel grade: СТ1
- Structure: 2
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 50 m/s
Wheel grade СТ1:
Medium-hard bond-holding characteristic.
- Retains abrasive grains more strongly
- Maintains the working profile well
- May glaze if the grinding load is too low
Structure 2:
Dense wheel structure.
- High abrasive-grain concentration
- Good retention of the working form
- Requires careful control of loading and heat generation
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 50 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.