300x50x50 14А Grinding wheel Type-1 F12 50 m/s on Bakelite bond Non-reinforced Т2 2

In stock
SKU
321239-1
$59.30
More Information
Bond Bakelite
Wheel type 1
D - top diameter 300
T - wheel thickness 50
H - hole diameter 50
Abrasive 14А
Grain it FEPA F12
Hardness Т2
Structure 2
Angle speed 50
Manufacturer ZAK
Country Ukraine

300×50×50 mm 14A Grinding Wheel – Type 1 – F12 – 50 m/s – Resinoid bond – Grade Т2 – Structure 2

Type 1 abrasive grinding wheel (straight wheel) in size 300×50×50 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.

Consistent results require the correct combination of feed, dressing, coolant application and contact area.

What it actually does:

FEPA grit F12 positions this wheel for heavy rough grinding with a high stock-removal rate.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.

Abrasive 14A — regular aluminium oxide:

A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.

  • Carbon and low-alloy steels
  • Steel billets, forgings and castings
  • Rough and semi-finish grinding

FEPA grit size F12:

Very coarse to coarse grain size for bonded abrasive products.

  • High stock-removal capacity
  • A pronounced abrasive scratch pattern
  • Usually requires an allowance for subsequent finishing

Resinoid bond:

  • More resilient than a vitrified bond
  • Tolerates dynamic grinding loads
  • Suitable for productive stock removal

Limitation: The non-reinforced construction must be used only on compatible stationary equipment.

In practice:

Before production use, make a trial pass and check heat generation, stock removal and the condition of the wheel face.

Specification:

  • Type: 1 (straight wheel)
  • Size: 300×50×50 mm
  • Outside diameter D: 300 mm
  • Wheel thickness T: 50 mm
  • Bore diameter H: 50 mm
  • Abrasive: 14A, regular aluminium oxide
  • Grit: FEPA F12
  • Wheel grade: Т2
  • Structure: 2
  • Bond: resinoid (Bakelite), non-reinforced
  • Maximum operating speed: 50 m/s

Wheel grade Т2:

Hard bond-holding characteristic.

  • Holds abrasive grains firmly in the bond
  • Provides strong resistance to profile wear
  • Requires the correct grinding load to avoid glazing and overheating

Structure 2:

Dense wheel structure.

  • High abrasive-grain concentration
  • Good retention of the working form
  • Requires careful control of loading and heat generation

Use for:

  • Peripheral grinding
  • Sharpening and sizing of working surfaces
  • Carbon and low-alloy steels
  • Steel billets, forgings and castings
  • Rough and semi-finish grinding

Do not use for:

  • Cemented carbide and technical ceramics
  • Precision grinding of hardened steel where a cooler-cutting friable grain is required
  • Side loading unless specifically permitted by the wheel design
  • Operation above 50 m/s

Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.

Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account
© Copyright - e-Store "Razvertka" Tokar tools - production and sale of tools You may not copy, reproduce, modify, publish, upload, transmit, and distribute any elements of this site, as well as their components, by any means and in any media without prior written permission.