We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
250x40x76 54С Grinding wheel Type-1 F16 25 m/s on Ceramic bond O 3
| Bond | Ceramic |
|---|---|
| Wheel type | 1 |
| D - top diameter | 250 |
| T - wheel thickness | 40 |
| H - hole diameter | 76 |
| Abrasive | 54С |
| Grain it FEPA | F16 |
| Hardness | O |
| Structure | 3 |
| Angle speed | 25 |
| Manufacturer | ZAK |
| Country | Ukraine |
250×40×76 mm 54C Grinding Wheel – Type 1 – F16 – 25 m/s – Vitrified bond – Grade O – Structure 3
Type 1 abrasive grinding wheel (straight wheel) in size 250×40×76 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
The abrasive, grit size and structure determine the stock-removal behaviour and the resulting surface condition.
What it actually does:
FEPA grit F16 positions this wheel for heavy rough grinding with a high stock-removal rate.
The main objective of this configuration is to balance stock removal with reliable profile retention.
Abrasive 54C — black silicon carbide:
A hard, sharp abrasive for low-tensile-strength materials and hard non-metallic surfaces.
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
FEPA grit size F16:
Very coarse to coarse grain size for bonded abrasive products.
- High stock-removal capacity
- A pronounced abrasive scratch pattern
- Usually requires an allowance for subsequent finishing
Vitrified bond:
- Provides strong form retention
- Can be dressed accurately
- Its porous matrix helps remove chips and heat
Limitation: Vitrified wheels are sensitive to impact and unauthorised side loading.
In practice:
If cutting action gives way to excessive rubbing, check the dressing condition, feed and coolant delivery.
Specification:
- Type: 1 (straight wheel)
- Size: 250×40×76 mm
- Outside diameter D: 250 mm
- Wheel thickness T: 40 mm
- Bore diameter H: 76 mm
- Abrasive: 54C, black silicon carbide
- Grit: FEPA F16
- Wheel grade: O
- Structure: 3
- Bond: vitrified
- Maximum operating speed: 25 m/s
Wheel grade O:
Medium-hard bond-holding characteristic.
- Retains abrasive grains more strongly
- Maintains the working profile well
- May glaze if the grinding load is too low
Structure 3:
Dense wheel structure.
- High abrasive-grain concentration
- Good retention of the working form
- Requires careful control of loading and heat generation
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
Do not use for:
- General-purpose grinding of carbon and alloy steels
- Operations with severe impact on the brittle abrasive grain
- Side loading unless specifically permitted by the wheel design
- Operation above 25 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.