We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
300x16x76.2 25А Grinding wheel Type-1 F120 35 m/s on Ceramic bond
| Bond | Ceramic |
|---|---|
| Wheel type | 1 |
| D - top diameter | 300 |
| T - wheel thickness | 16 |
| H - hole diameter | 76.2 |
| Abrasive | 25А |
| Grain it FEPA | F120 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
300×16×76.2 mm 25A Grinding Wheel – Type 1 – F120 – 35 m/s – Vitrified bond
Type 1 abrasive grinding wheel (straight wheel) in size 300×16×76.2 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
Performance depends not only on the dimensions, but also on the abrasive type, grit size, grade and structure.
What it actually does:
FEPA grit F120 positions this wheel for fine finishing and precision sizing.
The main objective of this configuration is to balance stock removal with reliable profile retention.
Abrasive 25A — white fused aluminium oxide:
A high-purity, sharp and friable grain that renews its cutting edges and helps reduce the risk of thermal damage.
- Hardened and tool steels
- High-speed and alloy steels
- Precision grinding and tool sharpening
FEPA grit size F120:
Very fine grain size for bonded abrasive products.
- Low stock removal per pass
- High surface uniformity
- Sensitive to overloading and wheel loading
Vitrified bond:
- Provides strong form retention
- Can be dressed accurately
- Its porous matrix helps remove chips and heat
Limitation: Vitrified wheels are sensitive to impact and unauthorised side loading.
In practice:
Repeatable results depend on accurate dressing, system rigidity and a consistent feed rate.
Specification:
- Type: 1 (straight wheel)
- Size: 300×16×76.2 mm
- Outside diameter D: 300 mm
- Wheel thickness T: 16 mm
- Bore diameter H: 76.2 mm
- Abrasive: 25A, white fused aluminium oxide
- Grit: FEPA F120
- Bond: vitrified
- Maximum operating speed: 35 m/s
Structure :
Dense wheel structure.
- High abrasive-grain concentration
- Good retention of the working form
- Requires careful control of loading and heat generation
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Hardened and tool steels
- High-speed and alloy steels
- Precision grinding and tool sharpening
Do not use for:
- Cemented carbide, glass and ceramics, where silicon carbide is generally more suitable
- Heavy snagging with severe impact loading
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.