We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
250x13x76 54С Grinding wheel Type-1 F100 35 m/s on Ceramic bond L 7
| Bond | Ceramic |
|---|---|
| Wheel type | 1 |
| D - top diameter | 250 |
| T - wheel thickness | 13 |
| H - hole diameter | 76 |
| Abrasive | 54С |
| Grain it FEPA | F100 |
| Hardness | L |
| Structure | 7 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
250×13×76 mm 54C Grinding Wheel – Type 1 – F100 – 35 m/s – Vitrified bond – Grade L – Structure 7
Type 1 abrasive grinding wheel (straight wheel) in size 250×13×76 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
The wheel acts as a multi-point cutting tool and must be installed on equipment designed for its mounting profile.
What it actually does:
FEPA grit F100 positions this wheel for finish grinding and final size correction.
The main objective of this configuration is to balance stock removal with reliable profile retention.
Abrasive 54C — black silicon carbide:
A hard, sharp abrasive for low-tensile-strength materials and hard non-metallic surfaces.
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
FEPA grit size F100:
Fine grain size for bonded abrasive products.
- Shallower grinding marks
- Controlled surface quality
- Requires stable feed and timely dressing
Vitrified bond:
- Provides strong form retention
- Can be dressed accurately
- Its porous matrix helps remove chips and heat
Limitation: Vitrified wheels are sensitive to impact and unauthorised side loading.
In practice:
Repeatable results depend on accurate dressing, system rigidity and a consistent feed rate.
Specification:
- Type: 1 (straight wheel)
- Size: 250×13×76 mm
- Outside diameter D: 250 mm
- Wheel thickness T: 13 mm
- Bore diameter H: 76 mm
- Abrasive: 54C, black silicon carbide
- Grit: FEPA F100
- Wheel grade: L
- Structure: 7
- Bond: vitrified
- Maximum operating speed: 35 m/s
Wheel grade L:
Medium-soft bond-holding characteristic.
- Supports regular renewal of cutting edges
- Performs well under moderate loading
- Requires monitoring of wheel wear and profile retention
Structure 7:
Moderately open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
Do not use for:
- General-purpose grinding of carbon and alloy steels
- Operations with severe impact on the brittle abrasive grain
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.