We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
150x32x32 54С Grinding wheel Type-1 F22 35 m/s on Bakelite bond Non-reinforced СТ1 5
| Bond | Bakelite |
|---|---|
| Wheel type | 1 |
| D - top diameter | 150 |
| T - wheel thickness | 32 |
| H - hole diameter | 32 |
| Abrasive | 54С |
| Grain it FEPA | F22 |
| Hardness | СТ1 |
| Structure | 5 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
150×32×32 mm 54C Grinding Wheel – Type 1 – F22 – 35 m/s – Resinoid bond – Grade СТ1 – Structure 5
Type 1 abrasive grinding wheel (straight wheel) in size 150×32×32 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
This wheel size is intended for stationary grinding under parameters matched to the machine and workpiece material.
What it actually does:
FEPA grit F22 positions this wheel for heavy rough grinding with a high stock-removal rate.
For this specification, maintain a clean, open and correctly dressed wheel surface.
Abrasive 54C — black silicon carbide:
A hard, sharp abrasive for low-tensile-strength materials and hard non-metallic surfaces.
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
FEPA grit size F22:
Very coarse to coarse grain size for bonded abrasive products.
- High stock-removal capacity
- A pronounced abrasive scratch pattern
- Usually requires an allowance for subsequent finishing
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
After mounting, verify free rotation, the safety guard and the no-load test required by the machine instructions.
Specification:
- Type: 1 (straight wheel)
- Size: 150×32×32 mm
- Outside diameter D: 150 mm
- Wheel thickness T: 32 mm
- Bore diameter H: 32 mm
- Abrasive: 54C, black silicon carbide
- Grit: FEPA F22
- Wheel grade: СТ1
- Structure: 5
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 35 m/s
Wheel grade СТ1:
Medium-hard bond-holding characteristic.
- Retains abrasive grains more strongly
- Maintains the working profile well
- May glaze if the grinding load is too low
Structure 5:
Medium wheel structure.
- Balanced grain and pore volume
- Stable form retention
- Predictable performance under consistent loading
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
Do not use for:
- General-purpose grinding of carbon and alloy steels
- Operations with severe impact on the brittle abrasive grain
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.