We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
400x80x127 14А Grinding wheel Type-1 F14 63 m/s on Bakelite bond Non-reinforced S 2
| Bond | Bakelite |
|---|---|
| Wheel type | 1 |
| D - top diameter | 400 |
| T - wheel thickness | 80 |
| H - hole diameter | 127 |
| Abrasive | 14А |
| Grain it FEPA | F14 |
| Hardness | S |
| Structure | 2 |
| Angle speed | 63 |
| Manufacturer | ZAK |
| Country | Ukraine |
400×80×127 mm 14A Grinding Wheel – Type 1 – F14 – 63 m/s – Resinoid bond – Grade S – Structure 2
Type 1 abrasive grinding wheel (straight wheel) in size 400×80×127 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
Consistent results require the correct combination of feed, dressing, coolant application and contact area.
What it actually does:
FEPA grit F14 positions this wheel for heavy rough grinding with a high stock-removal rate.
For this specification, maintain a clean, open and correctly dressed wheel surface.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F14:
Very coarse to coarse grain size for bonded abrasive products.
- High stock-removal capacity
- A pronounced abrasive scratch pattern
- Usually requires an allowance for subsequent finishing
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
With a large contact area, chip clearance, coolant supply and timely opening of the wheel face become especially important.
Specification:
- Type: 1 (straight wheel)
- Size: 400×80×127 mm
- Outside diameter D: 400 mm
- Wheel thickness T: 80 mm
- Bore diameter H: 127 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F14
- Wheel grade: S
- Structure: 2
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 63 m/s
Wheel grade S:
Hard bond-holding characteristic.
- Holds abrasive grains firmly in the bond
- Provides strong resistance to profile wear
- Requires the correct grinding load to avoid glazing and overheating
Structure 2:
Dense wheel structure.
- High abrasive-grain concentration
- Good retention of the working form
- Requires careful control of loading and heat generation
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 63 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.