We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
750x80x305 54С Grinding wheel Type-1 F46 35 m/s on Bakelite bond Non-reinforced С1 3
| Bond | Bakelite |
|---|---|
| Wheel type | 1 |
| D - top diameter | 750 |
| T - wheel thickness | 80 |
| H - hole diameter | 305 |
| Abrasive | 54С |
| Grain it FEPA | F46 |
| Hardness | С1 |
| Structure | 3 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
750×80×305 mm 54C Grinding Wheel – Type 1 – F46 – 35 m/s – Resinoid bond – Grade С1 – Structure 3
Type 1 abrasive grinding wheel (straight wheel) in size 750×80×305 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
This specification controls cutting-edge renewal, chip clearance and form retention during grinding.
What it actually does:
FEPA grit F46 positions this wheel for general roughing and semi-finishing.
For this specification, maintain a clean, open and correctly dressed wheel surface.
Abrasive 54C — black silicon carbide:
A hard, sharp abrasive for low-tensile-strength materials and hard non-metallic surfaces.
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
FEPA grit size F46:
Medium grain size for bonded abrasive products.
- Productive material removal
- Suitable for establishing geometry
- Leaves the surface ready for further finishing when tighter requirements apply
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
After mounting, verify free rotation, the safety guard and the no-load test required by the machine instructions.
Specification:
- Type: 1 (straight wheel)
- Size: 750×80×305 mm
- Outside diameter D: 750 mm
- Wheel thickness T: 80 mm
- Bore diameter H: 305 mm
- Abrasive: 54C, black silicon carbide
- Grit: FEPA F46
- Wheel grade: С1
- Structure: 3
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 35 m/s
Wheel grade С1:
Medium bond-holding characteristic.
- Balances self-sharpening and wheel life
- Stable performance with a consistent feed
- A versatile grade for steady grinding contact
Structure 3:
Dense wheel structure.
- High abrasive-grain concentration
- Good retention of the working form
- Requires careful control of loading and heat generation
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
Do not use for:
- General-purpose grinding of carbon and alloy steels
- Operations with severe impact on the brittle abrasive grain
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.