80x20x20 14А Grinding wheel Type-1 F24 50 m/s on Bakelite bond Non-reinforced Q 3

In stock
SKU
321217-10001
$2.11
More Information
Bond Bakelite
Wheel type 1
D - top diameter 80
T - wheel thickness 20
H - hole diameter 20
Abrasive 14А
Grain it FEPA F24
Hardness Q
Structure 3
Angle speed 50
Manufacturer ZAK
Country Ukraine

80×20×20 mm 14A Grinding Wheel – Type 1 – F24 – 50 m/s – Resinoid bond – Grade Q – Structure 3

Type 1 abrasive grinding wheel (straight wheel) in size 80×20×20 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.

This specification controls cutting-edge renewal, chip clearance and form retention during grinding.

What it actually does:

FEPA grit F24 positions this wheel for heavy rough grinding with a high stock-removal rate.
For this specification, maintain a clean, open and correctly dressed wheel surface.

Abrasive 14A — regular aluminium oxide:

A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.

  • Carbon and low-alloy steels
  • Steel billets, forgings and castings
  • Rough and semi-finish grinding

FEPA grit size F24:

Very coarse to coarse grain size for bonded abrasive products.

  • High stock-removal capacity
  • A pronounced abrasive scratch pattern
  • Usually requires an allowance for subsequent finishing

Resinoid bond:

  • More resilient than a vitrified bond
  • Tolerates dynamic grinding loads
  • Suitable for productive stock removal

Limitation: The non-reinforced construction must be used only on compatible stationary equipment.

In practice:

With a large contact area, chip clearance, coolant supply and timely opening of the wheel face become especially important.

Specification:

  • Type: 1 (straight wheel)
  • Size: 80×20×20 mm
  • Outside diameter D: 80 mm
  • Wheel thickness T: 20 mm
  • Bore diameter H: 20 mm
  • Abrasive: 14A, regular aluminium oxide
  • Grit: FEPA F24
  • Wheel grade: Q
  • Structure: 3
  • Bond: resinoid (Bakelite), non-reinforced
  • Maximum operating speed: 50 m/s

Wheel grade Q:

Hard bond-holding characteristic.

  • Holds abrasive grains firmly in the bond
  • Provides strong resistance to profile wear
  • Requires the correct grinding load to avoid glazing and overheating

Structure 3:

Dense wheel structure.

  • High abrasive-grain concentration
  • Good retention of the working form
  • Requires careful control of loading and heat generation

Use for:

  • Peripheral grinding
  • Sharpening and sizing of working surfaces
  • Carbon and low-alloy steels
  • Steel billets, forgings and castings
  • Rough and semi-finish grinding

Do not use for:

  • Cemented carbide and technical ceramics
  • Precision grinding of hardened steel where a cooler-cutting friable grain is required
  • Side loading unless specifically permitted by the wheel design
  • Operation above 50 m/s

Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.

Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account
© Copyright - e-Store "Razvertka" Tokar tools - production and sale of tools You may not copy, reproduce, modify, publish, upload, transmit, and distribute any elements of this site, as well as their components, by any means and in any media without prior written permission.