We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
900x80x305 54С Grinding wheel Type-1 F70 50 m/s on Bakelite bond Non-reinforced M 4
| Bond | Bakelite |
|---|---|
| Wheel type | 1 |
| D - top diameter | 900 |
| T - wheel thickness | 80 |
| H - hole diameter | 305 |
| Abrasive | 54С |
| Grain it FEPA | F70 |
| Hardness | M |
| Structure | 4 |
| Angle speed | 50 |
| Manufacturer | ZAK |
| Country | Ukraine |
900×80×305 mm 54C Grinding Wheel – Type 1 – F70 – 50 m/s – Resinoid bond – Grade M – Structure 4
Type 1 abrasive grinding wheel (straight wheel) in size 900×80×305 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
These parameters balance stock removal, wheel life and surface quality for the intended operation.
What it actually does:
FEPA grit F70 positions this wheel for semi-finish grinding with controlled stock removal.
For this specification, maintain a clean, open and correctly dressed wheel surface.
Abrasive 54C — black silicon carbide:
A hard, sharp abrasive for low-tensile-strength materials and hard non-metallic surfaces.
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
FEPA grit size F70:
Medium-fine grain size for bonded abrasive products.
- Balanced cutting performance
- A more uniform surface than coarse grits
- Suitable preparation for a finishing pass
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
After mounting, verify free rotation, the safety guard and the no-load test required by the machine instructions.
Specification:
- Type: 1 (straight wheel)
- Size: 900×80×305 mm
- Outside diameter D: 900 mm
- Wheel thickness T: 80 mm
- Bore diameter H: 305 mm
- Abrasive: 54C, black silicon carbide
- Grit: FEPA F70
- Wheel grade: M
- Structure: 4
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 50 m/s
Wheel grade M:
Medium bond-holding characteristic.
- Balances self-sharpening and wheel life
- Stable performance with a consistent feed
- A versatile grade for steady grinding contact
Structure 4:
Medium wheel structure.
- Balanced grain and pore volume
- Stable form retention
- Predictable performance under consistent loading
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
Do not use for:
- General-purpose grinding of carbon and alloy steels
- Operations with severe impact on the brittle abrasive grain
- Side loading unless specifically permitted by the wheel design
- Operation above 50 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.