We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
900x32x305 14А Grinding wheel Type-1 F46 35 m/s on Bakelite bond Non-reinforced СМ1 5
| Bond | Bakelite |
|---|---|
| Wheel type | 1 |
| D - top diameter | 900 |
| T - wheel thickness | 32 |
| H - hole diameter | 305 |
| Abrasive | 14А |
| Grain it FEPA | F46 |
| Hardness | СМ1 |
| Structure | 5 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
900×32×305 mm 14A Grinding Wheel – Type 1 – F46 – 35 m/s – Resinoid bond – Grade СМ1 – Structure 5
Type 1 abrasive grinding wheel (straight wheel) in size 900×32×305 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
The wheel acts as a multi-point cutting tool and must be installed on equipment designed for its mounting profile.
What it actually does:
FEPA grit F46 positions this wheel for general roughing and semi-finishing.
For this specification, maintain a clean, open and correctly dressed wheel surface.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F46:
Medium grain size for bonded abrasive products.
- Productive material removal
- Suitable for establishing geometry
- Leaves the surface ready for further finishing when tighter requirements apply
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
Determine feed and infeed by a controlled trial while checking size, surface quality and the absence of grinding burn.
Specification:
- Type: 1 (straight wheel)
- Size: 900×32×305 mm
- Outside diameter D: 900 mm
- Wheel thickness T: 32 mm
- Bore diameter H: 305 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F46
- Wheel grade: СМ1
- Structure: 5
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 35 m/s
Wheel grade СМ1:
Medium-soft bond-holding characteristic.
- Supports regular renewal of cutting edges
- Performs well under moderate loading
- Requires monitoring of wheel wear and profile retention
Structure 5:
Medium wheel structure.
- Balanced grain and pore volume
- Stable form retention
- Predictable performance under consistent loading
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.