We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
600x100x305 54С Grinding wheel Type-1 F22 35 m/s on Bakelite bond Non-reinforced М3 7
| Bond | Bakelite |
|---|---|
| Wheel type | 1 |
| D - top diameter | 600 |
| T - wheel thickness | 100 |
| H - hole diameter | 305 |
| Abrasive | 54С |
| Grain it FEPA | F22 |
| Hardness | М3 |
| Structure | 7 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
600×100×305 mm 54C Grinding Wheel – Type 1 – F22 – 35 m/s – Resinoid bond – Grade М3 – Structure 7
Type 1 abrasive grinding wheel (straight wheel) in size 600×100×305 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
The abrasive, grit size and structure determine the stock-removal behaviour and the resulting surface condition.
What it actually does:
FEPA grit F22 positions this wheel for heavy rough grinding with a high stock-removal rate.
For this specification, maintain a clean, open and correctly dressed wheel surface.
Abrasive 54C — black silicon carbide:
A hard, sharp abrasive for low-tensile-strength materials and hard non-metallic surfaces.
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
FEPA grit size F22:
Very coarse to coarse grain size for bonded abrasive products.
- High stock-removal capacity
- A pronounced abrasive scratch pattern
- Usually requires an allowance for subsequent finishing
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
Determine feed and infeed by a controlled trial while checking size, surface quality and the absence of grinding burn.
Specification:
- Type: 1 (straight wheel)
- Size: 600×100×305 mm
- Outside diameter D: 600 mm
- Wheel thickness T: 100 mm
- Bore diameter H: 305 mm
- Abrasive: 54C, black silicon carbide
- Grit: FEPA F22
- Wheel grade: М3
- Structure: 7
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 35 m/s
Wheel grade М3:
Soft bond-holding characteristic.
- Releases worn abrasive grains relatively quickly
- Promotes cooler cutting on hard workpiece materials
- Wears faster than harder wheel grades
Structure 7:
Moderately open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
Do not use for:
- General-purpose grinding of carbon and alloy steels
- Operations with severe impact on the brittle abrasive grain
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.