We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
500x150x305 14А Grinding wheel Type-1 F46 35 m/s on Bakelite bond Non-reinforced М3 7
| Bond | Bakelite |
|---|---|
| Wheel type | 1 |
| D - top diameter | 500 |
| T - wheel thickness | 150 |
| H - hole diameter | 305 |
| Abrasive | 14А |
| Grain it FEPA | F46 |
| Hardness | М3 |
| Structure | 7 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
500×150×305 mm 14A Grinding Wheel – Type 1 – F46 – 35 m/s – Resinoid bond – Grade М3 – Structure 7
Type 1 abrasive grinding wheel (straight wheel) in size 500×150×305 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
This wheel size is intended for stationary grinding under parameters matched to the machine and workpiece material.
What it actually does:
FEPA grit F46 positions this wheel for general roughing and semi-finishing.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F46:
Medium grain size for bonded abrasive products.
- Productive material removal
- Suitable for establishing geometry
- Leaves the surface ready for further finishing when tighter requirements apply
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
Start with a moderate feed and adjust the process according to surface condition, grinding sound and spindle load.
Specification:
- Type: 1 (straight wheel)
- Size: 500×150×305 mm
- Outside diameter D: 500 mm
- Wheel thickness T: 150 mm
- Bore diameter H: 305 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F46
- Wheel grade: М3
- Structure: 7
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 35 m/s
Wheel grade М3:
Soft bond-holding characteristic.
- Releases worn abrasive grains relatively quickly
- Promotes cooler cutting on hard workpiece materials
- Wears faster than harder wheel grades
Structure 7:
Moderately open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.