We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
750x40x305 14А Grinding wheel Type-1 F46 35 m/s on Bakelite bond Non-reinforced СМ1 5
| Bond | Bakelite |
|---|---|
| Wheel type | 1 |
| D - top diameter | 750 |
| T - wheel thickness | 40 |
| H - hole diameter | 305 |
| Abrasive | 14А |
| Grain it FEPA | F46 |
| Hardness | СМ1 |
| Structure | 5 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
750×40×305 mm 14A Grinding Wheel – Type 1 – F46 – 35 m/s – Resinoid bond – Grade СМ1 – Structure 5
Type 1 abrasive grinding wheel (straight wheel) in size 750×40×305 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
Consistent results require the correct combination of feed, dressing, coolant application and contact area.
What it actually does:
FEPA grit F46 positions this wheel for general roughing and semi-finishing.
For this specification, maintain a clean, open and correctly dressed wheel surface.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F46:
Medium grain size for bonded abrasive products.
- Productive material removal
- Suitable for establishing geometry
- Leaves the surface ready for further finishing when tighter requirements apply
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
Determine feed and infeed by a controlled trial while checking size, surface quality and the absence of grinding burn.
Specification:
- Type: 1 (straight wheel)
- Size: 750×40×305 mm
- Outside diameter D: 750 mm
- Wheel thickness T: 40 mm
- Bore diameter H: 305 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F46
- Wheel grade: СМ1
- Structure: 5
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 35 m/s
Wheel grade СМ1:
Medium-soft bond-holding characteristic.
- Supports regular renewal of cutting edges
- Performs well under moderate loading
- Requires monitoring of wheel wear and profile retention
Structure 5:
Medium wheel structure.
- Balanced grain and pore volume
- Stable form retention
- Predictable performance under consistent loading
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.