We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
350x40x127 54С Grinding wheel Type-1 F46 35 m/s on Bakelite bond Non-reinforced СМ1 4
| Bond | Bakelite |
|---|---|
| Wheel type | 1 |
| D - top diameter | 350 |
| T - wheel thickness | 40 |
| H - hole diameter | 127 |
| Abrasive | 54С |
| Grain it FEPA | F46 |
| Hardness | СМ1 |
| Structure | 4 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
350×40×127 mm 54C Grinding Wheel – Type 1 – F46 – 35 m/s – Resinoid bond – Grade СМ1 – Structure 4
Type 1 abrasive grinding wheel (straight wheel) in size 350×40×127 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
Performance depends not only on the dimensions, but also on the abrasive type, grit size, grade and structure.
What it actually does:
FEPA grit F46 positions this wheel for general roughing and semi-finishing.
For this specification, maintain a clean, open and correctly dressed wheel surface.
Abrasive 54C — black silicon carbide:
A hard, sharp abrasive for low-tensile-strength materials and hard non-metallic surfaces.
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
FEPA grit size F46:
Medium grain size for bonded abrasive products.
- Productive material removal
- Suitable for establishing geometry
- Leaves the surface ready for further finishing when tighter requirements apply
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
Dressing should restore geometry and cutting ability without unnecessarily weakening the working surface.
Specification:
- Type: 1 (straight wheel)
- Size: 350×40×127 mm
- Outside diameter D: 350 mm
- Wheel thickness T: 40 mm
- Bore diameter H: 127 mm
- Abrasive: 54C, black silicon carbide
- Grit: FEPA F46
- Wheel grade: СМ1
- Structure: 4
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 35 m/s
Wheel grade СМ1:
Medium-soft bond-holding characteristic.
- Supports regular renewal of cutting edges
- Performs well under moderate loading
- Requires monitoring of wheel wear and profile retention
Structure 4:
Medium wheel structure.
- Balanced grain and pore volume
- Stable form retention
- Predictable performance under consistent loading
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
Do not use for:
- General-purpose grinding of carbon and alloy steels
- Operations with severe impact on the brittle abrasive grain
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.