We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
450x25x127 25А Grinding wheel Type-1 F120 35 m/s on Ceramic bond
| Bond | Ceramic |
|---|---|
| Wheel type | 1 |
| D - top diameter | 450 |
| T - wheel thickness | 25 |
| H - hole diameter | 127 |
| Abrasive | 25А |
| Grain it FEPA | F120 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
450×25×127 mm 25A Grinding Wheel – Type 1 – F120 – 35 m/s – Vitrified bond
Type 1 abrasive grinding wheel (straight wheel) in size 450×25×127 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
This specification controls cutting-edge renewal, chip clearance and form retention during grinding.
What it actually does:
FEPA grit F120 positions this wheel for fine finishing and precision sizing.
For this specification, maintain a clean, open and correctly dressed wheel surface.
Abrasive 25A — white fused aluminium oxide:
A high-purity, sharp and friable grain that renews its cutting edges and helps reduce the risk of thermal damage.
- Hardened and tool steels
- High-speed and alloy steels
- Precision grinding and tool sharpening
FEPA grit size F120:
Very fine grain size for bonded abrasive products.
- Low stock removal per pass
- High surface uniformity
- Sensitive to overloading and wheel loading
Vitrified bond:
- Provides strong form retention
- Can be dressed accurately
- Its porous matrix helps remove chips and heat
Limitation: Vitrified wheels are sensitive to impact and unauthorised side loading.
In practice:
Before production use, make a trial pass and check heat generation, stock removal and the condition of the wheel face.
Specification:
- Type: 1 (straight wheel)
- Size: 450×25×127 mm
- Outside diameter D: 450 mm
- Wheel thickness T: 25 mm
- Bore diameter H: 127 mm
- Abrasive: 25A, white fused aluminium oxide
- Grit: FEPA F120
- Bond: vitrified
- Maximum operating speed: 35 m/s
Structure :
Dense wheel structure.
- High abrasive-grain concentration
- Good retention of the working form
- Requires careful control of loading and heat generation
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Hardened and tool steels
- High-speed and alloy steels
- Precision grinding and tool sharpening
Do not use for:
- Cemented carbide, glass and ceramics, where silicon carbide is generally more suitable
- Heavy snagging with severe impact loading
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.