We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
100x10x20 54С Grinding wheel Type-1 F60 35 m/s on Ceramic bond K 7
| Bond | Ceramic |
|---|---|
| Wheel type | 1 |
| D - top diameter | 100 |
| T - wheel thickness | 10 |
| H - hole diameter | 20 |
| Abrasive | 54С |
| Grain it FEPA | F60 |
| Hardness | K |
| Structure | 7 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
100×10×20 mm 54C Grinding Wheel – Type 1 – F60 – 35 m/s – Vitrified bond – Grade K – Structure 7
Type 1 abrasive grinding wheel (straight wheel) in size 100×10×20 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
This wheel size is intended for stationary grinding under parameters matched to the machine and workpiece material.
What it actually does:
FEPA grit F60 positions this wheel for semi-finish grinding with controlled stock removal.
For this specification, maintain a clean, open and correctly dressed wheel surface.
Abrasive 54C — black silicon carbide:
A hard, sharp abrasive for low-tensile-strength materials and hard non-metallic surfaces.
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
FEPA grit size F60:
Medium-fine grain size for bonded abrasive products.
- Balanced cutting performance
- A more uniform surface than coarse grits
- Suitable preparation for a finishing pass
Vitrified bond:
- Provides strong form retention
- Can be dressed accurately
- Its porous matrix helps remove chips and heat
Limitation: Vitrified wheels are sensitive to impact and unauthorised side loading.
In practice:
Before production use, make a trial pass and check heat generation, stock removal and the condition of the wheel face.
Specification:
- Type: 1 (straight wheel)
- Size: 100×10×20 mm
- Outside diameter D: 100 mm
- Wheel thickness T: 10 mm
- Bore diameter H: 20 mm
- Abrasive: 54C, black silicon carbide
- Grit: FEPA F60
- Wheel grade: K
- Structure: 7
- Bond: vitrified
- Maximum operating speed: 35 m/s
Wheel grade K:
Medium-soft bond-holding characteristic.
- Supports regular renewal of cutting edges
- Performs well under moderate loading
- Requires monitoring of wheel wear and profile retention
Structure 7:
Moderately open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Cast iron
- Non-ferrous metals and alloys
- Stone, glass and selected ceramic materials
Do not use for:
- General-purpose grinding of carbon and alloy steels
- Operations with severe impact on the brittle abrasive grain
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.