We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
500x100x305 25А Grinding wheel Type-1 F60 35 m/s on Ceramic bond O 6
| Bond | Ceramic |
|---|---|
| Wheel type | 1 |
| D - top diameter | 500 |
| T - wheel thickness | 100 |
| H - hole diameter | 305 |
| Abrasive | 25А |
| Grain it FEPA | F60 |
| Hardness | O |
| Structure | 6 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
500×100×305 mm 25A Grinding Wheel – Type 1 – F60 – 35 m/s – Vitrified bond – Grade O – Structure 6
Type 1 abrasive grinding wheel (straight wheel) in size 500×100×305 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
Performance depends not only on the dimensions, but also on the abrasive type, grit size, grade and structure.
What it actually does:
FEPA grit F60 positions this wheel for semi-finish grinding with controlled stock removal.
For this specification, maintain a clean, open and correctly dressed wheel surface.
Abrasive 25A — white fused aluminium oxide:
A high-purity, sharp and friable grain that renews its cutting edges and helps reduce the risk of thermal damage.
- Hardened and tool steels
- High-speed and alloy steels
- Precision grinding and tool sharpening
FEPA grit size F60:
Medium-fine grain size for bonded abrasive products.
- Balanced cutting performance
- A more uniform surface than coarse grits
- Suitable preparation for a finishing pass
Vitrified bond:
- Provides strong form retention
- Can be dressed accurately
- Its porous matrix helps remove chips and heat
Limitation: Vitrified wheels are sensitive to impact and unauthorised side loading.
In practice:
Repeatable results depend on accurate dressing, system rigidity and a consistent feed rate.
Specification:
- Type: 1 (straight wheel)
- Size: 500×100×305 mm
- Outside diameter D: 500 mm
- Wheel thickness T: 100 mm
- Bore diameter H: 305 mm
- Abrasive: 25A, white fused aluminium oxide
- Grit: FEPA F60
- Wheel grade: O
- Structure: 6
- Bond: vitrified
- Maximum operating speed: 35 m/s
Wheel grade O:
Medium-hard bond-holding characteristic.
- Retains abrasive grains more strongly
- Maintains the working profile well
- May glaze if the grinding load is too low
Structure 6:
Medium wheel structure.
- Balanced grain and pore volume
- Stable form retention
- Predictable performance under consistent loading
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Hardened and tool steels
- High-speed and alloy steels
- Precision grinding and tool sharpening
Do not use for:
- Cemented carbide, glass and ceramics, where silicon carbide is generally more suitable
- Heavy snagging with severe impact loading
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.