We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
350x100x203 14А Grinding wheel Type-1 F60 35 m/s on Bakelite bond Non-reinforced СТ1 5
| Bond | Bakelite |
|---|---|
| Wheel type | 1 |
| D - top diameter | 350 |
| T - wheel thickness | 100 |
| H - hole diameter | 203 |
| Abrasive | 14А |
| Grain it FEPA | F60 |
| Hardness | СТ1 |
| Structure | 5 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
350×100×203 mm 14A Grinding Wheel – Type 1 – F60 – 35 m/s – Resinoid bond – Grade СТ1 – Structure 5
Type 1 abrasive grinding wheel (straight wheel) in size 350×100×203 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
This specification controls cutting-edge renewal, chip clearance and form retention during grinding.
What it actually does:
FEPA grit F60 positions this wheel for semi-finish grinding with controlled stock removal.
Correct bore fit and flange compatibility are particularly important for this wheel configuration.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F60:
Medium-fine grain size for bonded abrasive products.
- Balanced cutting performance
- A more uniform surface than coarse grits
- Suitable preparation for a finishing pass
Resinoid bond:
- More resilient than a vitrified bond
- Tolerates dynamic grinding loads
- Suitable for productive stock removal
Limitation: The non-reinforced construction must be used only on compatible stationary equipment.
In practice:
Start with a moderate feed and adjust the process according to surface condition, grinding sound and spindle load.
Specification:
- Type: 1 (straight wheel)
- Size: 350×100×203 mm
- Outside diameter D: 350 mm
- Wheel thickness T: 100 mm
- Bore diameter H: 203 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F60
- Wheel grade: СТ1
- Structure: 5
- Bond: resinoid (Bakelite), non-reinforced
- Maximum operating speed: 35 m/s
Wheel grade СТ1:
Medium-hard bond-holding characteristic.
- Retains abrasive grains more strongly
- Maintains the working profile well
- May glaze if the grinding load is too low
Structure 5:
Medium wheel structure.
- Balanced grain and pore volume
- Stable form retention
- Predictable performance under consistent loading
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.