We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
200x32x32 64С Grinding wheel Type-1 F60 35 m/s on Ceramic bond P 7
| Bond | Ceramic |
|---|---|
| Wheel type | 1 |
| D - top diameter | 200 |
| T - wheel thickness | 32 |
| H - hole diameter | 32 |
| Abrasive | 64С |
| Grain it FEPA | F60 |
| Hardness | P |
| Structure | 7 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
200×32×32 mm 64C Grinding Wheel – Type 1 – F60 – 35 m/s – Vitrified bond – Grade P – Structure 7
Type 1 abrasive grinding wheel (straight wheel) in size 200×32×32 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
The wheel acts as a multi-point cutting tool and must be installed on equipment designed for its mounting profile.
What it actually does:
FEPA grit F60 positions this wheel for semi-finish grinding with controlled stock removal.
The main objective of this configuration is to balance stock removal with reliable profile retention.
Abrasive 64C — green silicon carbide:
A very hard and friable abrasive with sharp cutting edges for cemented carbides and brittle non-metallic materials.
- Cemented carbides
- Technical ceramics and glass
- Mineral materials and precision sharpening of carbide tools
FEPA grit size F60:
Medium-fine grain size for bonded abrasive products.
- Balanced cutting performance
- A more uniform surface than coarse grits
- Suitable preparation for a finishing pass
Vitrified bond:
- Provides strong form retention
- Can be dressed accurately
- Its porous matrix helps remove chips and heat
Limitation: Vitrified wheels are sensitive to impact and unauthorised side loading.
In practice:
After mounting, verify free rotation, the safety guard and the no-load test required by the machine instructions.
Specification:
- Type: 1 (straight wheel)
- Size: 200×32×32 mm
- Outside diameter D: 200 mm
- Wheel thickness T: 32 mm
- Bore diameter H: 32 mm
- Abrasive: 64C, green silicon carbide
- Grit: FEPA F60
- Wheel grade: P
- Structure: 7
- Bond: vitrified
- Maximum operating speed: 35 m/s
Wheel grade P:
Medium-hard bond-holding characteristic.
- Retains abrasive grains more strongly
- Maintains the working profile well
- May glaze if the grinding load is too low
Structure 7:
Moderately open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Cemented carbides
- Technical ceramics and glass
- Mineral materials and precision sharpening of carbide tools
Do not use for:
- Carbon and alloy steels as the primary workpiece material
- Heavy impact grinding
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.