We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
200x32x32 64С Grinding wheel Type-1 F60 35 m/s on Ceramic bond O 7
| Bond | Ceramic |
|---|---|
| Wheel type | 1 |
| D - top diameter | 200 |
| T - wheel thickness | 32 |
| H - hole diameter | 32 |
| Abrasive | 64С |
| Grain it FEPA | F60 |
| Hardness | O |
| Structure | 7 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
200×32×32 mm 64C Grinding Wheel – Type 1 – F60 – 35 m/s – Vitrified bond – Grade O – Structure 7
Type 1 abrasive grinding wheel (straight wheel) in size 200×32×32 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
These parameters balance stock removal, wheel life and surface quality for the intended operation.
What it actually does:
FEPA grit F60 positions this wheel for semi-finish grinding with controlled stock removal.
The main objective of this configuration is to balance stock removal with reliable profile retention.
Abrasive 64C — green silicon carbide:
A very hard and friable abrasive with sharp cutting edges for cemented carbides and brittle non-metallic materials.
- Cemented carbides
- Technical ceramics and glass
- Mineral materials and precision sharpening of carbide tools
FEPA grit size F60:
Medium-fine grain size for bonded abrasive products.
- Balanced cutting performance
- A more uniform surface than coarse grits
- Suitable preparation for a finishing pass
Vitrified bond:
- Provides strong form retention
- Can be dressed accurately
- Its porous matrix helps remove chips and heat
Limitation: Vitrified wheels are sensitive to impact and unauthorised side loading.
In practice:
After mounting, verify free rotation, the safety guard and the no-load test required by the machine instructions.
Specification:
- Type: 1 (straight wheel)
- Size: 200×32×32 mm
- Outside diameter D: 200 mm
- Wheel thickness T: 32 mm
- Bore diameter H: 32 mm
- Abrasive: 64C, green silicon carbide
- Grit: FEPA F60
- Wheel grade: O
- Structure: 7
- Bond: vitrified
- Maximum operating speed: 35 m/s
Wheel grade O:
Medium-hard bond-holding characteristic.
- Retains abrasive grains more strongly
- Maintains the working profile well
- May glaze if the grinding load is too low
Structure 7:
Moderately open wheel structure.
- More chip clearance
- Improved coolant access to the grinding zone
- Reduced risk of wheel loading during prolonged contact
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Cemented carbides
- Technical ceramics and glass
- Mineral materials and precision sharpening of carbide tools
Do not use for:
- Carbon and alloy steels as the primary workpiece material
- Heavy impact grinding
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.