We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
300x25x127 14А Grinding wheel Type-1 F46 35 m/s on Ceramic bond O 5
| Bond | Ceramic |
|---|---|
| Wheel type | 1 |
| D - top diameter | 300 |
| T - wheel thickness | 25 |
| H - hole diameter | 127 |
| Abrasive | 14А |
| Grain it FEPA | F46 |
| Hardness | O |
| Structure | 5 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
300×25×127 mm 14A Grinding Wheel – Type 1 – F46 – 35 m/s – Vitrified bond – Grade O – Structure 5
Type 1 abrasive grinding wheel (straight wheel) in size 300×25×127 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
This specification controls cutting-edge renewal, chip clearance and form retention during grinding.
What it actually does:
FEPA grit F46 positions this wheel for general roughing and semi-finishing.
The main objective of this configuration is to balance stock removal with reliable profile retention.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F46:
Medium grain size for bonded abrasive products.
- Productive material removal
- Suitable for establishing geometry
- Leaves the surface ready for further finishing when tighter requirements apply
Vitrified bond:
- Provides strong form retention
- Can be dressed accurately
- Its porous matrix helps remove chips and heat
Limitation: Vitrified wheels are sensitive to impact and unauthorised side loading.
In practice:
Before production use, make a trial pass and check heat generation, stock removal and the condition of the wheel face.
Specification:
- Type: 1 (straight wheel)
- Size: 300×25×127 mm
- Outside diameter D: 300 mm
- Wheel thickness T: 25 mm
- Bore diameter H: 127 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F46
- Wheel grade: O
- Structure: 5
- Bond: vitrified
- Maximum operating speed: 35 m/s
Wheel grade O:
Medium-hard bond-holding characteristic.
- Retains abrasive grains more strongly
- Maintains the working profile well
- May glaze if the grinding load is too low
Structure 5:
Medium wheel structure.
- Balanced grain and pore volume
- Stable form retention
- Predictable performance under consistent loading
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.