We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
500x100x305 14А Grinding wheel Type-1 F60 35 m/s on Ceramic bond Q 6
| Bond | Ceramic |
|---|---|
| Wheel type | 1 |
| D - top diameter | 500 |
| T - wheel thickness | 100 |
| H - hole diameter | 305 |
| Abrasive | 14А |
| Grain it FEPA | F60 |
| Hardness | Q |
| Structure | 6 |
| Angle speed | 35 |
| Manufacturer | ZAK |
| Country | Ukraine |
500×100×305 mm 14A Grinding Wheel – Type 1 – F60 – 35 m/s – Vitrified bond – Grade Q – Structure 6
Type 1 abrasive grinding wheel (straight wheel) in size 500×100×305 mm.
A versatile geometry for peripheral grinding, sharpening, surface grinding or cylindrical grinding, subject to the machine setup.
The abrasive, grit size and structure determine the stock-removal behaviour and the resulting surface condition.
What it actually does:
FEPA grit F60 positions this wheel for semi-finish grinding with controlled stock removal.
The main objective of this configuration is to balance stock removal with reliable profile retention.
Abrasive 14A — regular aluminium oxide:
A tough aluminium oxide grain designed for productive grinding of materials with high tensile strength.
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
FEPA grit size F60:
Medium-fine grain size for bonded abrasive products.
- Balanced cutting performance
- A more uniform surface than coarse grits
- Suitable preparation for a finishing pass
Vitrified bond:
- Provides strong form retention
- Can be dressed accurately
- Its porous matrix helps remove chips and heat
Limitation: Vitrified wheels are sensitive to impact and unauthorised side loading.
In practice:
Stable quality requires correct balancing, minimal runout and consistent dressing between grinding cycles.
Specification:
- Type: 1 (straight wheel)
- Size: 500×100×305 mm
- Outside diameter D: 500 mm
- Wheel thickness T: 100 mm
- Bore diameter H: 305 mm
- Abrasive: 14A, regular aluminium oxide
- Grit: FEPA F60
- Wheel grade: Q
- Structure: 6
- Bond: vitrified
- Maximum operating speed: 35 m/s
Wheel grade Q:
Hard bond-holding characteristic.
- Holds abrasive grains firmly in the bond
- Provides strong resistance to profile wear
- Requires the correct grinding load to avoid glazing and overheating
Structure 6:
Medium wheel structure.
- Balanced grain and pore volume
- Stable form retention
- Predictable performance under consistent loading
Use for:
- Peripheral grinding
- Sharpening and sizing of working surfaces
- Carbon and low-alloy steels
- Steel billets, forgings and castings
- Rough and semi-finish grinding
Do not use for:
- Cemented carbide and technical ceramics
- Precision grinding of hardened steel where a cooler-cutting friable grain is required
- Side loading unless specifically permitted by the wheel design
- Operation above 35 m/s
Before mounting, inspect the wheel for damage and confirm bore fit, mounting method and machine compatibility. Use the correct guard and follow the machine operating instructions.