1A1 straight grinding wheels 250x5x15x76 P B2-01 100% AC4 D 213

1A1 Diamond Grinding Wheel – FEPA D213 (212/180 μm) | AC4

Straight diamond wheel (1A1) for extreme rough grinding and maximum stock removal.
Designed for carbide, ceramics and other hard brittle materials.

What it actually does:

Removes large amounts of material as fast as possible.
Used for initial shaping and heavy stock removal where surface quality is not important.

Grain size (D213 ≈ 212/180 μm):

Ultra-coarse diamond grit for extreme-duty grinding.

• Maximum possible stock removal rate
• Typical Ra ~ 2.0–4.0 μm
• Leaves very deep, rough surface

Stable under extreme grinding conditions and heavy load.

In practice:

This is a bulk removal wheel.
Used as the first step in grinding sequence before D181 → D151 → D126.
Focus is speed and removing material, not precision.

Specification:

• Type: 1A1 (straight)
• Abrasive: Synthetic diamond (AC4)
• Grit: FEPA D213 ≈ 212/180 μm (ANSI 70/80)
• Concentration: 100%
• Body: P / S / Ap
  (Pressed / Steel / Aluplast)

Behavior:

• Extreme cutting aggressiveness
• Maximum productivity
• Very rough surface finish
• Note: requires full grinding sequence after

Body options:

• P: lighter, vibration damping
• S: maximum rigidity for extreme load
• Ap: balanced performance

Dimensions (D × X × T × H):

• D – outer diameter
• X – diamond layer thickness
• T – total thickness
• H – bore diameter

Use for:

• Carbide rough grinding
• Heavy stock removal
• Initial shaping
• Pre-processing before D181 / D151

Do not use for:

• Finishing
• Polishing
• Steel