1A1 straight grinding wheels 100x5x20x20 P B2-01 100% cBN1 B 181

1A1 CBN Grinding Wheel – FEPA B181 (180/150 μm) | CBN1

Straight CBN grinding wheel (1A1) for extreme rough grinding and maximum stock removal on hardened steels.
Designed for HSS, tool steel and other ferrous materials.

What it actually does:

Removes large amounts of material at maximum speed.
Used for initial shaping where productivity is more important than surface quality.

Grain size (B181 ≈ 180/150 μm):

Extra coarse grit for heavy-duty grinding.

• Maximum stock removal rate
• Typical Ra ~ 1.5–3.0 μm
• Leaves very rough surface

Stable under heavy grinding conditions and high load.

In practice:

This is a primary roughing wheel.
Used as the first step before B151 → B126 → B107.
Focus is bulk material removal and speed.

Specification:

• Type: 1A1 (straight)
• Abrasive: Cubic Boron Nitride (CBN1)
• Grit: FEPA B181 ≈ 180/150 μm (ANSI 80/100)
• Concentration: 100%
• Body: P / S / Ap
  (Pressed / Steel / Aluplast)

Behavior:

• Extreme cutting aggressiveness
• Maximum productivity
• Very low surface quality
• Note: requires full grinding sequence after

Body options:

• P: lighter, vibration damping
• S: maximum rigidity for extreme load
• Ap: balanced performance

Dimensions (D × X × T × H):

• D – outer diameter
• X – abrasive layer
• T – total thickness
• H – bore diameter

Use for:

• HSS grinding
• Tool steel
• Hardened components
• Heavy stock removal

Do not use for:

• Carbide
• Ceramics
• Non-ferrous materials