1FF1 flat grinding wheels with double-sided conical profile 125x4x5x8x32 P B2-01 100% ACH M 16
| D - top diameter | 125 |
|---|---|
| R - radius | 4 |
| X - diamond layer | 5 |
| T - wheel thickness | 8 |
| H - hole diameter | 32 |
| Body | P |
| Concentration | 100% |
| Diamond type | ACH |
| Size FEPA | M 16 |
| Bond type | B2-01 |
| Type of Operation | Polishing |
| Manufacturer | Poltava ZAI |
| Country of Manufacture | Ukraine |
--B2-01-Bond.jpg)
1FF1 Diamond Grinding Wheel – Double-Sided Conical Profile | FEPA M16 (14/10 μm)
1FF1 flat diamond wheel with double-sided conical profile for precision grinding of cutting tool features.
Designed for carbide and other hard brittle materials.
Where it is actually used:
Used for grinding chip-breaking flutes and narrow profiles on cutting tools.
Typical applications include:
- Chip breaker geometry on end mills and drills
- Narrow flutes and grooves
- Profile features requiring controlled geometry
The double-sided conical profile enables precise geometry generation with controlled contact.
What it actually does:
Fine grinding and geometry refinement of profile features.
Controlled material removal for pre-finishing, ensuring stable geometry and consistent surface quality.
Grain size (M16 ≈ 14/10 μm):
- Fine finish with slight stock removal
- Typical Ra ~ 0.04–0.10 μm
- Good balance between cutting ability and surface quality
More forgiving than M10, but still requires stable setup and clean coolant.
In practice:
This is a pre-finish wheel for profile features.
Used after M25 / M20 and before M10 final finishing.
Focus is geometry stabilization before final surface refinement.
Specification:
- Type: 1FF1 (double-sided conical)
- Abrasive: Synthetic diamond (АСН)
- Grit: FEPA M16 ≈ 14/10 μm (ANSI ~1200–1500)
- Concentration: 100%
-
Body: P / A / S / Ap
(Pressed / Aluminum / Steel / Aluplast)
Body options:
- P (Pressed): lighter weight, vibration damping, better surface finish
- A (Aluminum): lightweight with good rigidity, general-purpose solution
- S (Steel): maximum rigidity for heavy-duty grinding
- Ap (Aluplast): balanced weight and rigidity
Why this shape:
- Access to narrow grooves
- Controlled profile generation
- No interference in tight areas
Use for:
- Chip breaker flutes
- Tool profile grinding
- Pre-finishing of grooves
Do not use for:
- Open flat surfaces
- Final polishing (use M10)
- Heavy stock removal