1A1 straight grinding wheels 150x5x6x20 P B2-01 100% ACH M 25

1A1 Diamond Grinding Wheel – FEPA M25 (28/20 μm) | B2-01 Bond

Straight diamond wheel (1A1) for semi-finish grinding and surface preparation.
Designed for carbide, ceramics and other hard brittle materials.

What it actually does:

Pre-finishing with moderate stock removal and controlled surface quality.
Acts as a bridge between rough grinding (D46/D64) and fine finishing (M20/M16).

Grain size (M25 ≈ 28/20 μm):

Fine grit at the start of finishing range.

• Removes material faster than M20/M16
• Typical Ra ~ 0.08–0.20 μm
• Good step for stabilizing geometry before fine stages

More stable and forgiving than finer micron grits.

Bond (B2-01):

• Self-sharpening
• Controlled heat generation
• Stable cutting behavior
• Optimized for semi-finish operations

In practice:

This is a pre-finish wheel.
Used after rough grinding to clean geometry before M20/M16.
Works best after D46 → D25 sequence.

Specification:

• Type: 1A1 (straight)
• Abrasive: Synthetic diamond (АСН)
• Grit: FEPA M25 ≈ 28/20 μm
• Bond: B2-01 (resin-based)
• Concentration: 100%
• Body: P (pressed composite)
  (Aluminum or Steel on request)

Concentration 100%:

• Stable cutting performance
• Consistent material removal
• Long tool life
• Note: may load under excessive pressure

Body type (P):

• Lightweight construction
• Vibration damping effect
• Improves surface consistency
• Limit: less rigid than steel

Use for:

• Carbide semi-finishing
• Geometry stabilization
• Pre-finishing before M20/M16
• Ceramics / glass

Do not use for:

• Steel
• Heavy rough grinding
• Unstable grinding conditions