1A1 straight grinding wheels 100x5x20x20 P B2-01 100% AC4 D 181

1A1 Diamond Grinding Wheel – FEPA D181 (180/150 μm) | AC4

Straight diamond wheel (1A1) for extreme rough grinding and maximum stock removal.
Designed for carbide, ceramics and other hard brittle materials.

What it actually does:

Very aggressive material removal at maximum productivity.
Used for removing large stock and initial shaping of workpieces.

Grain size (D181 ≈ 180/150 μm):

Extra coarse diamond grit for heavy-duty grinding.

• Maximum stock removal rate
• Typical Ra ~ 1.5–3.0 μm
• Leaves very deep and visible scratches

Stable under heavy grinding conditions and high load.

In practice:

This is a primary roughing wheel.
Used as the first step in grinding sequence before D151 → D126 → D107.
Focus is speed and bulk material removal.

Specification:

• Type: 1A1 (straight)
• Abrasive: Synthetic diamond (AC4)
• Grit: FEPA D181 ≈ 180/150 μm (ANSI 80/100)
• Concentration: 100%
• Body: P / S / Ap
  (Pressed / Steel / Aluplast)

Behavior:

• Maximum aggressiveness
• Highest productivity
• Very low surface quality
• Note: requires full grinding sequence after

Body options:

• P: lighter, better vibration damping
• S: maximum rigidity for extreme load
• Ap: balanced performance

Dimensions (D × X × T × H):

• D – outer diameter
• X – diamond layer thickness
• T – total thickness
• H – bore diameter

Use for:

• Carbide rough grinding
• Heavy stock removal
• Initial shaping
• Pre-processing before D151 / D126

Do not use for:

• Finishing
• Polishing
• Steel